75
Scanner Memory
Using V-Scanners
You can save active scanner configurations (called
“working” or “main” memory) to a V-Scanner
storage folder for later use. Then recall the stored
scanner configurations from a V-Scanner storage
folder to main memory when you want to use them.
When you recall a configuration from a V-Scanner
storage folder and use it in main memory, any
changes you make while using the configuration
will not automatically be transferred to the
configuration data stored in the V-Scanner
storage folder. You must save your changes back
to that folder location if you want to preserve
them for later use.
When you load a new configuration into main
memory, the contents of main memory are
overwritten and lost, unless you save your main
memory to a V-Scanner storage folder first. Once
the configuration data in main memory has been
overwritten, it cannot be recovered—there is no
“Undo” function.
Saving Main Memory to a V-Scanner Folder
1. Press FUNC, then PGM to enter V-Scanner
mode.
2. Press the Stor softkey.
3. Press p or q to scroll to the desired
V-Scanner folder, then press the Stor
softkey.
4. If the selected V-Scanner folder already
contains data, you will be asked if you wish
to overwrite the existing data with new data
from your current version of main memory.
Press the YES softkey to proceed, or the NO
softkey to cancel.
To Next Page
Loading...
