51
Organizing Objects
3. Press t or u to scroll to display the filter
softkeys. The filter softkeys are as follows:
CONV
TGRP
TSYS
SRCH
STLK
4. Press the softkey that corresponds with that
object type to filter.
5. Press p, q, t or u to browse filtered objects.
Object Lockout
When an object is locked out, traffic is not
received on that object until it is unlocked, even if
the object is mapped to more than one Scan List.
Locking out an object locks it out “radio-wide”
until it is enabled by toggling the lockout setting.
Four types of lockout functions are available:
temporary lockout, permanent lockout, search
lockout, and talkgroup lockout.
Temporary Lockout
Temporary lockout locks out an object until
the scanner is turned off. When the scanner is
powered on again, all objects that have been
temporarily locked out are restored.
To temporarily lockout an object:
1. When the scanner stops on an object, press
L/OUT.
or
1. In Manual Mode or Program Mode, press p,
q, t or u to select an object.
2. Press L/OUT.
The lowercase “l” in the display flashes to
indicate the object is temporary lockout.
To Next Page
Loading...
