73
Weather Scanning
2. Press p or q to find the best weather radio
transmitter for your location, then press the
stby softkey.
The softkey will change to STBY to indicate
that SAME Standby Mode is active, and the
scanner will alert when a matching SAME
message is received.
3. Press the STBY softkey again to exit SAME
Standby Mode, or press MAN, SCAN, or
PGM.
When your local NWS office activates a SAME
warning that matches a FIPS code stored in your
scanner, you will first hear a siren alarm and see
the LED flash to alert you to the incoming alarm.
The LED flashes RED for warnings, YELLOW for
watches, and BLUE for tests and administrative
messages.
The scanner sounds the siren until the NWS
transmission of the 1050 Hz Warning Alert
Tone (WAT) begins. Once the WAT begins, the
scanner’s speaker will unmute, and you will hear
the WAT play as an alert that the voice portion
of the SAME warning is about to begin. You will
then hear the voice portion of the SAME warning.
Your scanner will resume SAME Standby
operation 90 seconds after the SAME warning
starts. You may reset standby mode by pressing
the STBY softkey twice at any time.
To Next Page
Loading...
