84
Advanced Settings
4. Press p, q to scroll to the TSYS item
and press the SEL key to edit the TSYS
parameters.
5. Press t or u to scroll to Multi-Site.
6. Press t or u to select Off, Stat or Roam.
Off: the scanner will find the first usable
control channel in the control channel list and
use it until it is no longer usable.
Stat (Stationary): the scanner will track the
system using any control channel in the list
that is usable.
Roam: the scanner will attempt to locate
and use the best possible control channel
and ignore others, until the control channel
is no longer usable, then it will locate a new
“best control channel” to use. The scanner
will always attempt to lock on to control
channels where the decoding quality is
greater than the Threshold Hi setting, and
will search for new control channels when
the decoding quality of a control channel
drops below Threshold Lo setting. If no new
control channels are available that meet the
Threshold Hi criteria, the scanner will seek
the best control channel to use, and continue
checking periodically for a new control
channel that meets the Threshold Hi criteria.
7. Press SAVE softkey to save your changes to
the TSYS parameters.
8. Press SAVE softkey again to use the scanner.
You should experiment with the different Multi-
site modes and the threshold settings to find a
combination that works best for your location.
To Next Page
Loading...
