15
• If batteries are installed, make sure the battery
switch inside the battery compartment is set to the
correct position (see “Using Internal Batteries” on
Page 10).
1. Turn
VOLUME/OFF
counterclockwise until it clicks
to make sure the power is turned off.
2. If the adapter has a voltage switch, set the switch
to 9V.
3. Insert the Adaptaplug into the adapter’s cord so it
reads TIP
–.
Insert the Adaptaplug into the PRO-
94’s
POWER 9V 300MA
jack.
4. Plug the adapter’s barrel plug into your scanner’s
POWER 9V 300MA
jack.
5. Plug the other end of the adapter into your vehi-
cle’s cigarette-lighter socket.
If rechargeable batteries are installed and
ALKALINE
JACK NI-CD
is set to
NI-CD
, the adapter powers the
scanner and recharges the installed batteries at the
same time.
Note:
If the scanner does not operate properly when
you use a DC adapter, unplug the adapter from the
cigarette-lighter socket and clean the socket to remove
ashes and debris.
20-524.fm Page 15 Tuesday, August 31, 1999 3:55 PM
To Next Page
Loading...
