Radio Shack PRO-94 - Using HOLD to Monitor an Active Talk Group ID; Temporarily Storing a Talk Group ID into the Monitor ID Memory

49
Using HOLD to Monitor an
Active Talk Group ID
Follow these steps to stop scanning and keep the scan-
ner tuned to a desired ID.
1. Press
HOLD (A/B)
.
HOLD
appears and the scanner
stays on the current ID.
2. If you want to listen to (and hold) a different ID, use
the number keys to enter that ID.
3. Press
HOLD (A/B)
again.
HOLD
flashes, then the
scanner monitors the ID.
4. Press
SRC
to resume searching for a data channel
(trunk scanning).
Temporarily Storing a Talk Group ID into
the Monitor ID Memory
To store a talk group ID into a temporary monitor mem-
ory, press
MON/CLR (•)
. This lets you store the ID prior
to moving it into a list memory. Press
SRC
to resume
searching.
Note:
To program the ID stored in the monitor ID mem-
ory into the ID scan list, see “Moving Talk Group IDs to
Talk Group ID Lists” on Page 54.
20-524.fm Page 49 Tuesday, August 31, 1999 3:55 PM