27
SEARCHING FOR AND
TEMPORARILY STORING ACTIVE
FREQUENCIES
If you do not have a reference to frequencies in your ar-
ea, use a limit, direct, or service search (except weather
service search) to find a transmission. Also see “Guide
to the Action Bands” on Page 64.
Notes:
While doing a limit, direct, or service bank
search, press
:
•
DELAY
if you want the scanner to pause 2 seconds
after a transmission ends before it proceeds to the
next frequency (see “Delay” on Page 33).
•
DATA
if you want the scanner to skip data signals
(such as fax or modem signals) and search only for
audio (voice) signals (see “Skipping Data Signals”
on Page 38).
Limit Search
A limit search lets you search within a specific range
of frequencies.
-L- appears during a limit search.
1. Press
PROG
, then
LIMIT (SRC)
.
Lo
and
29.000
MHz
appear. 29.000 MHz is the low end of the
scanner’s range.
2. Enter the frequency that is the lower limit of the
range you want to search (including the decimal
point), then press
E
.
3. Press
LIMIT
.
Hi
and
1300.000
MHz
appear.
1300.000 MHz is the upper limit of the scanner’s
range.
20-524.fm Page 27 Tuesday, August 31, 1999 3:55 PM
To Next Page
Loading...
