28
4. Enter the frequency that is the upper limit of the
range you want to search (including the decimal
point), then press
E (SVC)
again.
5. Press
W
to search from the upper to the lower limit,
or
V
to search from the lower to the upper limit.
6. When the scanner stops on a transmission, quickly
press either:
•
HOLD (A/B)
to stop searching to listen to the
transmission.
HOLD
appears.
•
MON/CLR (•)
to store the displayed frequency
into the current monitor memory.
7. To release the hold and continue searching, press
HOLD (A/B)
or hold down
W
or
V
for at least 1 sec-
ond. Or, if you did not press
MON/CLR (•)
, simply
press
W
or
V
to continue searching.
Direct Search
You can search up or down from the currently displayed
frequency using direct search.
-d-
appears during
searching until the scanner stops. See Step 4.
1. Press
MAN
.
2. Enter the frequency you want to start from using
the number keys. (Press
•
to enter a decimal
point).
Notes:
• To start the search from a frequency already
stored in one of your scanner’s channels, press
MAN
or
PROG
. Then use the number keys to
enter the channel number and then press
MAN
or
PROG
again.
• If you enter an invalid frequency, the scanner
displays
Error.
Press
MON/CLR (•)
.
3. Press
W
to search downward or
V
to search
upward from the selected frequency.
-d-
,
SEARCH
, and
W
or
V
appear.
4. When the scanner stops on a transmission, quickly
press either:
•
HOLD
to stop searching and listen to the trans-
mission.
HOLD
appears.
20-524.fm Page 28 Tuesday, August 31, 1999 3:55 PM
To Next Page
Loading...
