72
RESETTING THE SCANNER
If the scanner’s display locks up or stops operating
properly, you might need to reset the scanner.
Caution:
This procedure clears all the information you
have stored in the scanner. Before you reset the scan-
ner, try turning it off and on to see if it begins working
properly. Reset the scanner only when you are sure it is
not working properly.
1. Turn off the scanner.
2. While holding down the
2
and
9
keys, turn on the
scanner.
CLEAR
flashes for about 5 seconds as
the scanner clears its memory.
Note:
Do not turn off the scanner again until
CLEAR
stops flashing. Otherwise, the scanner might not clear
its memory properly.
Channel activity
bars are flashing
but no sound is
heard.
The transmis-
sion might be a
private or tele-
phone intercon-
nect call. The
scanner does not
scan these types
of transmissions.
Scan for another
transmission.
The ID shown is
not active.
Wait for the ID to
become active, or
scan another
transmission.
Problem Possible Cause Remedy
20-524.fm Page 72 Tuesday, August 31, 1999 3:55 PM
To Next Page
Loading...
