Radio Shack PRO-94 - Locking out Talk Group Ids; Unlocking a Single Talk Group ID; Unlocking All Talk Group Ids

50
Locking Out Talk Group IDs
Many municipal and commercial services use trunk
systems to transmit signals from such devices as water
meter transmitters, door alarms, and traffic signals.
Some signals are encrypted, as well, and most are not
voice signals. Since all these are assigned IDs just like
other users, you may want to lock out reception of
these ID signals. You can lock out up to 100 IDs at one
time.
Note:
If you lock out an ID while searching, it is also
locked out of the scan list(s). See “Using Talk Group ID
Lists” on Page 52.
To lock out an ID, press
L-OUT (S/S)
when the ID ap-
pears. The ID is locked out, and the next active ID ap-
pears.
Unlocking a Single Talk Group ID
1. Hold down
L-OUT (S/S)
until you hear two short
beeps.
2. Repeatedly press
W
or
V
to select the ID you want
to unlock.
3. Press
L-OUT (S/S)
. The ID is unlocked, and the
next locked ID appears.
4. Press
SRC (LIMIT)
to resume the scanner’s previ-
ously selected function.
Unlocking All Talk Group IDs
Hold down
L-OUT (S/S)
while searching until you hear
two short beeps, then press
E (SVC)
to unlock all the
IDs at once. The scanner beeps twice. Press
L-OUT/SS
to resume the search.
Note:
When you unlock all the IDs, the scan list ap-
pears. Press
SCAN
to scan the IDs stored in your scan
lists or press
SRC (LIMIT)
to resume the scanner’s previ-
ously selected function. For more information about
scan lists, see “Using Talk Group ID Lists” on Page 52.
20-524.fm Page 50 Tuesday, August 31, 1999 3:55 PM