54
Moving Talk Group IDs to
Talk Group ID Lists
1. Press
MAN
.
MAN
appears.
2. Select the ID scan list location where you want to
store the IDs, then press
PROG
.
PGM
appears.
3. Press
MON/CLR
. A monitor ID appears.
4. Press
E
. The scanner stores the IDs into the
selected ID scan list.
Scanning the Talk Group ID Lists
Press
SCAN
to begin scanning the lists you have
stored.
Note:
If one or more of the IDs you stored are incorrect,
Error
flashes twice and the scanner beeps several
times, then the scan list numbers appear at the top of
the display. To correct the entry, delete at least one of
the incorrect IDs (see “Deleting a Stored Talk Group ID
List”).
To remove a scan list from active scanning, use the
number keys to enter the scan list’s number. The scan
list number turns off, and the IDs in that list are not
scanned.
Note:
One of the five scan lists must always be active.
You cannot remove all of them.
To restore a scan list to active scanning, use the num-
ber keys to enter the number of the list again.
Press
SRC
to return to the previously selected function.
Deleting a Stored Talk Group ID List
1. Press
PROG
.
PGM
appears.
2. Repeatedly press
V
or
W
to select the talk group
ID list location (shown at the top of the display) you
want to delete.
3. Press
0
then
E
.
20-524.fm Page 54 Tuesday, August 31, 1999 3:55 PM
To Next Page
Loading...
