RadioLink AT10 - A LOOK AT THE RADIOS FUNCTIONS STEP BY STEP

20
GOALS of EXAMPLE STEPS INPUTS for EXAMPLE
Set the second (low) rate throws and
exponential.
A to down position.
C
to
D/R
.
Repeat steps above to set low rate.
Optional: change dual rate switch
assignment. Ex: elevator to switch G
(AT10) or E (AT10) with 3 positions.
C
to
SW
. to
G
or
E
.
G or E to center position.
Repeat steps above to set 3rd rate.
Where next? (Other functions you may wish to set up for your model.)
TRAINER
p. 34.
0XOWLSOHZLQJDQGRUWDLOVHUYRVVHHZLQJW\SHVDQGWDLOW\SHVS
Elevator-to-flap, Rudder-to-aileron, flap-to-elevator, and other programmable
mixes p. 53.
Retractable Gear, Flaps on a Switch, Smoke systems, kill switches, and other
auxiliary channel setups. p. 34.
$/22.$77+(5$',26)81&7,21667(3%<67(3
MODEL
submenu: includes three functions that manage model memory:
MODEL SELECT
,
MODELCOPY
and
MODELNAME
. Since
these functions are all related, and are all basic features used with most models, they are together in the
MODEL
submenu of
the
BASIC
menu.
NOTE: When you choose a new model in the
MODEL SELECT
function, if the new
model is set to the other modulation, you must cycle the transmitter power to change
PRGXODWLRQV,I\RXGRQRWF\FOHWKHSRZHUWKHPRGXODWLRQW\SH
ZLOOÀDVKRQWKHKRPH
screen to remind you. You are still transmitting on the other modulation until you
affect this change.
GOAL: STEPS: INPUTS:
Select Model #3.
NOTE: This is one of several
functions for which the radio requires
FRQ¿UPDWLRQWRPDNHDFKDQJH
Open
BASIC
menu, then open
MODEL
submenu.
for 1 second.
(If
ADVANCE
,
again.)
if required to
MODEL
Choose Model #3.
to
3
.
&RQ¿UP\RXUFKDQJH
for 1 second.
Are you sure?
displays.
Close.
Confirm proper modulation of new
model memory.
If
2.4G
 DUH ÀDVKLQJ LQ WKH XSSHU ULJKW KDQG FRUQHU WKHQ WKH QHZ
PRGHOLVVHWIRUWKHRWKHUUHFHLYHUW\SH7XUQWKHWUDQVPLWWHU
RIIRQWRFKDQJHWKH
modulation.
Where next?
NAME
the model: see p. 22.
Change
MODEL TYPE
(aircraft, heli, glider): see p. 23.
Utilize servo
REVERSE
: see p. 26.
Adjust
END POINTs
: see p. 27.
Set up
IDLE-DOWN
and
THR-CUT
for throttle management: see p. 28, 29.
MODEL SELECT
: This function selects which of the 15 model memories in the
WUDQVPLWWHU WR VHW XS RUfly.
)RUFODULW\WKHPRGHOVQDPHDQGDQLPDJHRILWVW\SHDUHLQGLFDWHGDIWHULWV
number. (Each model memory may be a different model type from the other
memories.)
38,45.