RadioLink AT10 User Manual

63
Mixes:
• Linear Programmable mixes (
PROG.MIX1-4
): fully assignable programmable mixes with a linear response.
• Curved Programmable mixes (
PROG.MIX5-8
): fully assignable programmable mixes with a curved response.
•
ELEV-FLAP
SUHSURJUDPPHGPL[FUHDWHVHOHYDWRUPRYHPHQWIURPWKHLQERDUGÀDSVDVZHOODVHOHYDWRUV
•
BUTTERFLY
: Often called crow,
BUTTERFLY
is the glider version of
AIRBRAKE
. (
BUTTERFLY
does not have the option to
activate it solely from a switch, and its activation switch. It always provides progressively more
BUTTERFLY
as the
CHANNEL 3 (THROTTLE) STICK is lowered, or raised if used
THR-REV
) See
AIRBRAKE.
Full Span Mixing: Flap-to-Aileron and Aileron-to-Flap
•
CAMBER-MIX

AILE-FLAP
7KLV SUHSURJUDPPHG PL[ LV XVHG WR FUHDWH IXOO VSDQ ÀDSDLOHURQ DFWLRQ RQ D JOLGHU ZLWK 
ZLQJVHUYRV7KLVFKDQJHVWKHFDPEHURYHUWKHHQWLUHZLQJZKLFKSURGXFHVOHVVGUDJWKDQMXVWGURSSLQJWKHÀDSVE\
themselves.
NOTE: When you have
ELEV-FLAP
mixing also, the trailing edge droops with the elevators, increasing pitch response.
AILE

RUDD
(
GLID
):
Adjustability:
•
RATE
range of -100 to +100. Negative setting would result in opposite rudder (aileron) action from aileron (rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. Set up
LOGIC SW
: See p. 26.
•
POSITION
fully assignable, including
NULL
(mix always on) and
Up&Cntr
and
Cntr&Dn
to activate the mix in 2 separate
positions of the same SWITCH.
• Condition: The separate
AILE

RUDD
VHWWLQJVIRUHDFKÀLJKWFRQGLWLRQFDQEHVHW
You can select a pre-programed mix which is used to mix the rudders with
aileron operation or the ailerons with rudder operation.
Aileron-to-rudder mix (
AILE
ĺ
RUDD
): automatically creates a "coordinated turn".
Rudder -to-aileron mix (
RUDD
ĺ
AILE
): used to counterract undesirable roll (roll
coupling) that happens with rudder input, especially in knife-edge.
GOAL of EXAMPLE: STEPS: INPUTS:
([58''ĺ$,/(QRVZLWFK
corrects roll coupling.
Open
AILE

RUDD
mix submenu.
for 1 second.
(If
BASIC
, again.)
C
to
AILE

RUDD
.
Select the mixing mode.
C
to
MODE
. to
RUDD
ĺ
AILE
Activate the function.
C
to
MIX
to
ON
.
Set the rate. (Ex:
100%
each way)
C
to
FLP1
.
RUDDER STICK. to
+25%
.
RUDDER STICK. to
+25%
.
Repeat as needed.
Close.
Where next?
ELEV-FLAP
mixing. See p. 48.
BUTTERFLY
. See p. 48.
Use a mix to
OFFSET
WKHÀDSVDVHWGLVWDQFHRQDVSHFL¿HGVZLWFKVHHS
View additional model setups on the internet: www.radiolink.com.cn/doce.

RadioLink AT10 Specifications

General

Channels	10
Frequency	2.4GHz
Output Signal	PPM
Control Distance	1.5km
Compatibility	Compatible with most multi-rotor, airplane, helicopter and car models