RadioLink AT10 - Logic Sw

26
GOAL of EXAMPLE: STEPS: INPUTS:
Name
USER NAME
“Radiolink”. Open
BASIC
menu, then open
PARAMETER
submenu.
for 1 second.
(If
ADVANCE
, again.)
C
to
PARAMETER
.
Go to
USER NAME
and select the first
character. (Ex: _ to F)
Choose the next character to change.
C
Repeat the prior steps to complete
naming the model.
to
u
(note: lower case is available)
Repeat.
Close.
C
to
USER NAME
to
F
.
Logic switch selection (
LOGIC SW
): The various functions in the AT10 can be selected by switch. The Logic switch can be
assigned to the following functions:
THR-CUT
,
IDLE DOWN
,
AUX-CH
,
TIMER
,
PROG. MIX
,
AIRBRAKE
,
ELEV-FLAP
, and
AILE-FLAP
functions. The logic switch can activate functions by two switches combination. The 2 types of logic, either AND or OR,
can be selected.
Adjustability:
• Three logic switches can be used.
(LSW1
,
LSW2
, and
LSW3
)
• SW(1): Any SWICH A-H or THR-
STKS, SW(2): Any SWICH A-H
• Switch position (
POSI
)
• Logic mode: AND or OR (
MODE
)
Logic combination table:
SWITCH LOGIC
SW(1) SW(2) AND OR
off off off off
off on off on
on off off on
on on on on
GOAL of EXAMPLE: STEPS: INPUTS:
Ex: Switch A and B are calculated by
AND logic. (A = down, B = down)
Open BASIC menu, then open
LOGIC
SW
menu.
for 1 second.
(If
ADVANCE
, again.)
C
to
LOGIC SW
.
Go to
POSI
and change setting.
(Ex:
DOWN
)
C
to
POSI
.
to
DOWN
.
Next,
SW
=
B
,
POSI
=
DOWN
Repeat.
Close.
Servo reversing (
REVERSE
): changes the direction an individual servo responds to a CONTROL STICK motion.
[Since channel 9 and 10 are switch only , its servo
REVERSE
is in the
AUX-CH
control screen with its switch assignment.
For CCPM helicopters, be sure to read the section on
SWASH AFR
(p. 75) before reversing any servos.