RadioLink AT10II - Page 70

Radiolink Electronic Ltd
www.radiolink.com
65
Select proper mode type. Ex:
HELI H-1. Confirm the
change.
Close.
to HELICOPTER. for 1 sec. ‘Are you sure?’
displays , to SWASH ,
to H-1
for
1sec,’Are you sure ?’ displays. to confirm.
Then , NAME the
model.
In the BASIC menu, find
PARAMETER.
to MODEL SEL.
Go to MODEL SEL.-NAME
to Name(1
st
character is highlighted)
Input name.
to change the first character.
Close the submenu when
done.
When proper character is display. to next. Repeat.
Goals
Steps
Inputs
Reverse servos as needed for
proper control operation. Ex:
Left Rudder Stick results in
leading edges of tail rotor
blades moving left. Reverse to
operate properly.
In BASIC menu, open
Reverse.
for 1s to BASIC.(If
ADVANCE again) .
to REVERSE ,
Choose desired servo and
reverse its direction of travel.
Ex: reverse rudder servo.
to CH4:RUDD , to REV is
highlighted. ‘Are you sure ?’ displays
for 1 sec.
Adjust travels as needed to
match model’s recommended
throws.(usually listed as high
rates.
In BASIC menu, choose END
POINT.
to END POINT to choose end
point.
Adjust the servo’s end points.
(Ex: elevator servo).
Return to BASIC menu.
to ELEV. Elevator Stick ,
until up travel is as desired. Elevator
Stick , until down travel is as
desired.
Repeat as needed.
Activate THR-CUT.
Open THROTTLE-CUT
function.
to THR CUT
Activate the function. Choose
desired switch and position to
activate.
to MIX, , to OFF
to SW , to SwC,
to POSI , to DOWN,
With THROTTLE STICK at
idle, adjust the rate until the
engine consistently shuts off,
but throttle linkage is not
binding.Close
SwC to down position， Throttle
Stick ，to RATE ， until shuts off.