8.3.4. Setting date
Press navigating arrow key to enter settings of parameter 04 Date
Following procedure described in point 8.3.3 set current date value. After
setting the date return to the weighing mode following procedure specified in point
7.1 of this user manual.
8.3.5. Setting displaying criteria for date and time
Moisture analyzer MAX series enables declaring whether date and time
should be visible in the upper bar of the display during instrument operation. The
displaying criteria are modifiable by setting an appropriate value of the parameter.
The value is changed in accordance with specification given in point 7.1 of this
user manual. If the parameter value is set to 1 then date and time re visible in the
upper bargraph of the display.
8.4. Setting moisture analyzer operating parameters
Moisture analyzer MAX series enables adjusting its operation to current
ambient conditions (filter) or user needs (display refreshment, autozero, last digit).
The parameters are grouped in menu <P4 Readout>.
8.4.1. Entering menu group P4 Readout
Enter menu group P4 Readout
8.4.2. Filter settings
Depending on current ambient conditions at a workstation it is necessary to set
filtering value. In case of perfect operating conditions set the filter value to very fast
(set value of parameter 01 Filter to 1). If the conditions are bad (i.e. vibrations, air
To Next Page
Loading...
