RADWAG MAX 60

- 34 -
8.6. Printouts
User of a moisture analyzer MAX series
can set up to 5 different printout
templates whic
h are sent from the
instrument to a connected peripheral
device (a printer or a computer) through
the RS 232 slot.
- A single STANDARD printout
containing data enabled in the
GLP procedures
- Four NON-STANDARD
customized printout templates
8.6.1. Standard printout template
On pressing ENTER / PRINT key the moisture analyzer sends through the RS 232
interface current display status (mass of weighed load) and variables declared in
submenu P2 GLP.
Examples of standard printout templates in weighing mode:
A question mark preceding the mass value means that the mass readout was
unstable at the moment of printout release.
A printout can be divided into three sections:
• Header (containing data on selected drying mode and start mass of a
sample to be dried)
• Line (containing partial drying time and humidity content result)
• Footer (containing end mass, total drying time and final drying result).
Date: 22/10/2001
Hour: 13.04.23
User: Wilk
Project: XW/456
62.690 g
Date: 22/10/2001
Hour: 13.16.49
User: Wilk
Project: XW/456
Balance: 10
? 62.685 g
62.690 g