RADWAG MAX 60

- 49 -
After setting the Result criterion go to
setting the following parameters of a
drying process.
In order to set other parameters of the
drying process press ENTER key. The
software returns to displaying the initial
window.
Press DOWN navigating arrow key to
go to the following step of drying
process determination, i.e. Printout
Interval.
The printout interval is a period of time
measured in seconds in which a
moisture analyzers sends current
measurement result to a connected
peripheral device.
After setting the printout interval
criterion the moisture analyzer is
ready to start drying process of a
sample to be tested.
In order to finish setting the drying
mode parameters and go to the
humidity content determining process
press ENTER key. The software
returns to displaying the initial
window.