Function GIVE SOFTWARE REVISION
Command RV CR LF (sends software name)
Function GIVE OR CHANGE DATE IN A BALANCE
Command PD CR LF (causes sending data on set date or changes the date)
Function GIVE OR CHANGE TIME IN A BALANCE
Command PD CR LF (causes sending data on set time or changes the time)
Function GIVE ENABLED WORKING MODE
Command PM CR LF (causes sending by a balance a code of enabled
working mode)
Function SEND SETUP
Command PS CR LF (causes sending the complete setup - parameter
printout)
Function “BEEP” SOUND
Command B CR LF (causes immediate activating of beep sound in a
balance)
Function GIVE LAST CODE ERROR
Command ER CR LF (causes sending code of last saved error in a balance)
Function DISABLE AUTOZERO
Command A0 CR LF (causes disabling (switching off) autozero operation)
Function ENABLE AUTOZERO
Command A1 CR LF (causes enabling (switching on) autozero operation)
Caution!
If a non-existing or incorrect command finished with CR LF is sent to a
balance, it responses with E S CR LF. Spaces between characters should
be omitted, as they are added only for the purpose of proper legibility.
To Next Page
Loading...
