www.raisecom.com User Manual
91
In this status use → to change the configured value: Retain & Clear, presses ENTER to confirm, and
the relative cross connect will be deleted.
(There are four steps of this configuration:, Group No. for Delete Cross, Time Slot Start No. for
Delete Cross, Time Slot Number for Delete Cross, and Delete Relation: delete this group or delete
both this group and the retain group.)
Users can use these commands when delete a continuous cross connect, for example the next cross
connect is required:
Delete cross connect of cross group 1 1-5 channels and its correlation configuration:
Group No. for Delete Cross:1
Time Slot Start No. for Delete Cross:1
Time Slot Number for Delete Cross:5
Delete Relation: Clear
Then cross connect of cross group 1 1-5 channels and its correlation configuration will be deleted.
A.23 REV.A work mode Set
Press 3 in command Setting menu to enter REV.A work mode set:
Setting command:1-4, show menu: M; exit: Q; Command: 3
REV.A work mode set: Enable
In this status, use → key to change setting value: Enable or Disable. ENTER key and E key will
confirm the setting and exit; ESC key will cancel input and exit the menu.
Support 10-line mode
In configure command menu, press 4 to enter to 10-line supporting modes, shown as below:
Set command:1-4, show menu: M, exit: Q command:4
10-line setting mode: enable
In this state, press→ key to change the setting value: enable or disable. Enter key and E keys
indicate that the setting validation is complete, exit the setting; press Esc key to cancel the input, exit
the settings.
10-line mode is a new function applied on RC3000-SUB-10FXS and RC3000-SUB-10FXO sub-card.
When enable this mode, RC3000-SUB-10FXS/10FXO sub-card can occupy 10 timeslots, when this
mode disable, RC3000-SUB-10FXS/10FXO only occupy 8 timeslots, where 2 line of voice is
unavailable.
A.25 Operate menu
In main menu press number key 6 there will be Operate menu:
1.System Reset
2.Mute
To Next Page
Loading...
