Raisecom RC3000 - E1 Set; Use Set; Mode Set; Mask Set

www.raisecom.com User Manual
76
A.12 E1 Set
This section will explain the command in E1 Setting menu.
A.12.1 Use Set
In E1 Setting menu press number key 1 to configure the E1 using status:
First E1: Using
In this status use → key to shift configured value: Enable or Disable; use ↓↑ to change configuration
items; Press ENTER to confirm configuration, press E key to finish configuration, and ESC to cancel
configuration.
Configuration items are: First E1; Second E1; Third E1 and Fourth E1.
A.12.2 Mode Set
In E1 Setting menu press number key 2 to configure the E1 frame structure:
First E1 Mode: PCM30
In this status use → key to change E1 frame format: PCM30 or PCM31; use ↓ ↑ to change
configuration items; Press ENTER to confirm configuration, press E key to finish configuration, and
ESC to cancel configuration.
Configuration items are: First E1 Mode, Second E1 Mode, Third E1 Mode and Fourth E1 Mode
A.12.3 Mask Set
In E1 Setting menu press number key 3 to configure alarm mask:
First E1:(Enable)
In this status use → key to change E1 alarm mask (enable or mask); use ↓ ↑ to change configuration
items; Press ENTER to confirm configuration, press E key to finish configuration, and ESC to cancel
configuration.
Configuration items are:
First E1; First E1 LOS; First E1 AIS; First E1 LOF
First E1 RAL; First E1 LOMF; First E1 CRC LOMF
First E1 CRC Alarm
Second E1; Second E1 LOS; Second E1 AIS; Second E1 LOF
Second E1 RAL; Second E1 LOMF; Second E1 CRC LOMF
Second E1 CRC Alarm
Third E1; Third E1 LOS; Third E1 AIS; Third E1 LOF
Third E1 RAL; Third E1 LOMF; Third E1 CRC LOMF
Third E1 CRC Alarm