www.raisecom.com User Manual
63
16 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24
24 25 | 26 | 27 | 28 | 29 | 30 | 31
State Query Command:1-2, Menu Display: M, Return: Q Command:
Note: the data in each cell is hex and refer to receive signal information of user board, through this
command you can get the device work status.
A.6.2 Transmit State Query
In state information query menu press number key 2 there will be the following information:
Input Group No.(1-4, Esc=Cancel):
Enter group number 1, there will transmit signal status information:
First Group Transmit State
Channel 1 2 3 4 5 6 7 8
state 0 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8
8 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16
16 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24
24 25 | 26 | 27 | 28 | 29 | 30 | 31
State Query Command:1-2, Menu Display: M, Return: Q Command:
Note: the data in each cell is hex and refer to transmit signal information of user board, through this
command you can get the signaling status of user card.
A.7 Alarm Query menu
In main menu press number key 4, there will be alarm query menu:
1.Device Alarm
2.System Alarm
Alarm Query Command:1-2, Menu Display: M, Return: Q Command:
A.7.1 Device Alarm
In alarm query menu press number key 1 there will be present device alarm information:
Device Alarm:
1E1 Alarm: LOS, AIS, LOF, RAL, LOMF, CRC LOMF
2E1 Alarm:No Alarm
Local optical interface: No Alarm
Remote optical interface: No Alarm
Alarm Query Command:1-2, Menu Display: M, Return: Q Command:
Note: E1 interface alarms include: LOS, AIS, LOF, RAL, LOMF, CRC and CRC LOMF
Optical interface alarms include: Optical LOS, Frame LOF , E-3 ERROR and E-6 ERROR
To Next Page
Loading...
