Raisecom RC3000 - Sub-Card Information (EEPROM); Cross Set Query Menu

www.raisecom.com User Manual
59
Signal: None Signal In: Original Signal Out: Reversal Original
Signal Bit(D7:D0):A A A A
Sub-card type 15:
Type: 15 Ethernet interface Board (version B) Timeslot Number: 0 Set Mode: Software
PCB version: REV A.3 CPLD version: REV 1.0
Signal: None
Channel: Main channel
Auto-negotiation: Enable
Default setting of auto-negotiation defeat: 100M Full-duplex
LINK state: LINK UP
Work state: 100M Full-duplex
Sub-card type 16:
Type: 16 Dual-Ethernet interface Board Timeslot Number: 12 Set Mode: Software
PCB version: REV A.1 CPLD version: REV 1.0
1
st
Ethernet info:
Timeslot number: 8 Channel: Main channel
Auto-negotiation: Enable Default setting of auto-negotiation defeat: 100M Full-duplex
LINK state: LINK UP Work state: 100M Full-duplex
2
nd
Ethernet info:
Channel number: 4 Channel: Independent channel
Auto-negotiation: Enable Default setting of auto-negotiation defeat: 100M Full-duplex
LINK state: LINK UP Work state: 100M Full-duplex
Other sub-cards without definition:
Type: XX Timeslot Number: X Set Mode: Hardware
PCB version: REV A.3 CPLD version: REV 1.0
Signal: Exist Mode 1: 0 Mode 2: 0
Setting content(CH1:CH2) : 0 0 0 0 0 0 0 0
State content(CH1:CH2) : 1 1 1 1 1 1 1 1
A.4.8 Sub-card information (EEPROM)
Device Set Query menu press number key 8 you can get the same information saved in EEPROM as
Sub-card information (RAM)
A.5 Cross Set Query menu:
In main menu press number key 2, there will be Cross Set Query menu:
1.Four E1 Cross Query(RAM)