Raisecom RC3000 - System Alarm; Setting Menu; System Setting Menu

www.raisecom.com User Manual
64
Alarms include: E1 interface alarms and up-link board alarms. There are E1 interface alarms only
when that E1 interface is used, so are line-board alarms.
A.7.2 System Alarm
In alarm query menu press number key 2 there will be system alarm information:
System Alarm:
EEPROM Block: Main:Correct(T T T) E1 Block:Correct(T T T)
2M Block:Correct(T T T) Version:Correct(T T T)
User Board Com: 1: Success 2: Fail 3:Success
(conflict in setting card time slot)
Line Board Com: Success
Temp Sensor: Normal 2
5℃
Fans: Normal
Alarm Query Command:1-2, Menu Display: M, Return: Q Command:
Note: Used card timeslot collision alarm won’t display until the conflict generated.
A.8 Setting menu
In main menu press number key 5 and there will be setting menu:
1.System Set
2.Cross Set
3. Version A work mode set
4 supporting 10-line mode setting
Set Command:1-2, Menu Display: M, Return: Q Command:
A.9 System Setting menu
In setting menu press number key 1 there will be system setting menu:
1.ID Set
2.Baud Rate Set
3.Line Board Set
4.E1 Set
5.Clock Set
6.Net Topology Set
7.Alarm Sound Set
8.User Board Set
9.DCD of V35V24 Board and CTS Alarm Set
System Set Command:1-9, Menu Display: M, Return: Q Command: