www.raisecom.com User Manual
52
Ether Net E-Port: Open Link State: Link Up
Auto negotiation: Enable AUTO_MDI/MDIX: Disable
Ethernet status: 100M Full-duplex
Send Limited Bandwidth:1200 x 32Kbps
Receive Limited Bandwidth:1200 x 32Kbps
Display of 2E1 Line-Board:
Line-Board Type:Optical Board + 2E1
Software Version:REV 1.0 PCB Version:REV @.1
Optical Module Type: AS1
Alarm Mask: 1=Mask Optical LOS| Frame LOF | E-3 ERROR | E-6 ERROR
Local: 0 0 0 0
Remote: 0 0 0 0
3E1 without signal | 4E1 without signal
Local: 0 0
Remote: 0 0
Loopback State: no loop
2E1 Line-Board:
Line-Board Type: 2E1 line-board
PCB Version: REV A.3
2E1 with ADM function:
Line-Board Type: 2E1 ADM line-board
PCB Version: REV A.3
4E1 line-board:
Line-Board Type: 4E1 line-board
PCB Version: REV A.3
For the line-board have not been named, showing as:
Line-Board Type: without name
Mode 1
：
0 0 0 0 0 0 0 0 Mode 2
：
0 0 0 0 0 0 0 0
Mode 3
：
0 0 0 0 0 0 0 0 Mode 4
：
0 0 0 0 0 0 0 0
Mode 5
：
0 0 0 0 0 0 0 0 Mode 6
：
0 0 0 0 0 0 0 0
Mode 7
：
0 0 0 0 0 0 0 0
Status 1
：
0 0 0 0 0 0 0 0 Status 2
：
0 0 0 0 0 0 0 0
Status 3
：
0 0 0 0 0 0 0 0 Status 4
：
0 0 0 0 0 0 0 0
Status 5
：
0 0 0 0 0 0 0 0
A.4.3 Line-Board information (EEPROM)
In device set query menu press number key 3, and then there will be device Line-Board information:
To Next Page
Loading...
