www.raisecom.com User Manual
73
configuration.
The alarms are:
Local Optical Loss; Local LOF; Local E-3 ERR; Local E-6 ERR;
Remote Optical Loss; Remote LOF; Remote E-3 ERR; Remote E-6 ERR
A.10.2 Loopback Set
In optical line-board setting menu press number key 2 to configure loopback of optical line:
Optical Loopback Set:
Loopback Direction: Remote
In this status use → key to change configured value (local/remote or enable/disable); use ↓↑ to
change configuration items; Press ENTER to confirm configuration, press E key to finish
configuration, and ESC to cancel configuration.
The configuration items are:
Loopback Direction; 1E1 Loopback; 2E1 Loopback; 3E1 Loopback; 4E1 Loopback
A.10.3 ALS Set
In optical line-board setting menu press number key 3 to configure ALS function (the precondition is
optical module has this function):
ALS function: Enable
In this status use → key to change configured value (enable or disable); Press ENTER to confirm
configuration, press E key to finish configuration, and ESC to cancel configuration.
If the optical module does not have this function there will be prompt:
Optical Model hasn't ALS function, Can't be set.
Optical Board (Ethernet) Set Command:1-7, Menu Display: M, Return: Q Command:
A.10.4 Ether Net Port Set
In optical line-board setting menu press number key 4 to configure Ethernet interface:
Ether Net Port: Open
In this status use → key to change configured value (open or close); Press ENTER to confirm
configuration, press E key to finish configuration, and ESC to cancel configuration.
A.10.5 Ether Net Port Work Set
In optical line-board setting menu press number key 5 to configure Ethernet interface work status:
Ether Net Work State Set:
Auto Mode: Enable
In this status use → key to change configured value (enable or disable); use ↓↑ to change
To Next Page
Loading...
