www.raisecom.com User Manual
58
Defeat Link Default Set: Full Duplex
Link State:Link UP
Work State:Full Duplex
Note: Band Width Buffer is used to adjust buffer to reduce latency.
Sub-card type 9 RS232 serial interface user card:
Type: 9 RS232 User Board Timeslot Number: 8 Set Mode: Hardware
PCB version: REV A.3 CPLD version: REV 1.0
Signal: None
Band Width:64Kbps
Note: the bandwidth configuration can be only 64kbps or 128kbps; there are 8 channels at 64kbps
and 4 channels at 128kbps.
Sub-card type 10 RS422 serial interface user card:
Type:10 RS422 Board Timeslot Number: 8 Set Mode:Hardware
PCB version: REV A.3 CPLD version: REV 1.0
Signal:Exist
Band Width:64Kbps
Note: the bandwidth configuration can be only 64kbps or 128kbps; there are 8 channels at 64kbps
and 4 channels at 128kbps.
Sub-card type 11 magneto telephone card:
Type:11 Magneto Board Timeslot Number: 8 Set Mode:Hardware
PCB version: REV A.3 CPLD version: REV 1.0
Signal: Exist Signal In: Original Signal Out: Reversal Original
Signal Bit(D7:D0):A A A A B B B B
Sub-card type 12 FXS polarity reversible user card:
Type:11 FXS polarity reversible Board Timeslot Number: 8 Set Mode:Hardware
PCB version: REV A.3 CPLD version: REV 1.0
Signal: Exist Signal In: Original Signal Out: Reversal Original
Signal Bit(D7:D0):A A A A B B B B
Sub-card type 13:
Type: 12 R485 interface Board Timeslot Number: 8 Set Mode:Hardware
PCB version: REV A.3 CPLD version: REV 1.0
Signal: None
Bandwidth: 64Kbps
Note: the bandwidth configuration can be only 64kbps or 128kbps; there are 8 channels at 64kbps
and 4 channels at 128kbps.
Sub-card type 14:
Type: 14 FXS polarity reversible Board Timeslot Number: 4 Set Mode: Hardware
PCB version: REV A.3 CPLD version: REV 1.0
To Next Page
Loading...
