www.raisecom.com User Manual
71
2. Set bandwidth of port 2, phase adjust
3. Set bandwidth of port 3, phase adjust
4. Set bandwidth of port 4, phase adjust
Sub-card 1 (V24 User Board) Set Command:1-4, Menu Display: M, Return: Q Command:
Note: the command explanation is available in A.15 V24 User Board Setting menu.
When the sub-card type is 8 (Ethernet data sub-card), the menu will be:
1. Sub-Board Slot Number
2. Channel Select
3. Buffer Size Set
4. Default Port Mode
5. Reset Ether Net Port
Sub-card 1 (Ether Net Board) Set Command:1-5, Menu Display: M, Return: Q Command:
Note: the command explanation is available in A.16 10BaseT Ethernet sub-card setting menu.
When the sub-card type is 9 (RS232 data sub-card), 10 (RS422 data sub-card) and 13 (RS485 data
sub-card) the menu will be:
1.Channel Band Width Set
Sub-card 1 (RS232 Board) Set Command:1-1, Menu Display: M, Return: Q Command:
Note: the command explanation is available in A.17 RS232, RS422 and RS485 sub-card setting
menu.
When the sub-card type is 15 (10/100BaseT auto-negotiation Ethernet sub-card) the menu will be:
1. Sub-Board Slot Number
2. Channel Select
3. Auto-negotiation Set
4. Default Port Mode
5. Reset Ether Net Port
Sub-card 1 (Ether Net Board) Set Command:1-5, Menu Display: M, Return: Q Command:
Note: the command explanation is available in A.18 Ethernet data sub-card setting menu.
When the sub-card type is 16 (double lines 10/100BaseT auto-negotiation Ethernet sub-card) the
menu will be:
1. Sub-Board Slot Number of line 1
2. Channel Select of line 1
3. Auto-negotiation Set of line 1
4. Default Port Mode of line 1
To Next Page
Loading...
