Rand Tablet User Manual 3
Mounting the Rand Tablet
1. Your Device
Suction cup mount
Note: Follow all local regulations governing the placement of the mount.
1. Select an area with a line of sight to the sky and GPS satellites.
2. Clean and dry the mounting area.
3. Remove the suction cup protective lm.
4. Adjust the angle of the mount.
5. Pull the suction cup lever up to release suction.
6. Plug the power cord into the mount and the
vehicle’s 12-volt power source.
7. Place and hold the mount suction cup against
the mounting surface.
8. Press the suction cup lever down until it snaps into place.
9. Snap the tablet onto the mount (using built-in magnet).
To Next Page
Loading...
