R&S NRP8S User Manual

Remote Control Commands
R&S
®
NRPxxS(N)
120User Manual 1177.5079.02 ─ 10
The "Upload Calibration Data" dialog opens. It shows a list of the available sen-
sors.
3. If you cannot find your power sensor in the list, for example because of reconnect-
ing the power sensor, you can reload the list by clicking "Rebuild List".
4. Click "Upload" to load calibration data from the power sensor.
After the upload is finished, the "OK" button is enabled.
5. Click "OK" to apply the changes.
If you want to discard the changes, exit the dialog by clicking "Cancel".
After a successful upload, the name and serial number is shown in the name of the
main dialog.
Configuring Basic Measurement Parameters

R&S NRP8S Specifications

General

Brand	R&S
Model	NRP8S
Category	Accessories
Language	English