Operating instructions D30+ │ P30+ │ SheraPrint 30
Rapid Shape GmbH │ DOCR000231
3.1 Safety during transport
CA UTION !
Risk of injury due to heavy loads!
The machine weighs up to 50 kg. Improper transport
can result in back problems.
— Always lift and transport the machine with two
people.
— Use suitable lifting and transport equipment.
CA UTION !
Risk of injury due to falling loads!
If the machine falls, there is a risk that body parts can be
crushed.
— When transporting the machine, wear suitable
protective clothing.
— Before starting the transport, it must be checked
that the machine is secured to the lifting and
transporting equipment with transport safety
devices.
— Before starting the transport check that the
transport route is clear of obstacles.
NOTE!
Material damage caused by improper transport!
Improper transport may cause the machine to fall. This
can cause material damage.
— The machine may only be transported by trained
qualified personnel.
— Always lift and transport the machine with two
people.
— In the event of subsequent transport of the
machine, it must be ensured before the start of
transport that no auxiliary materials are present in
the machine interior.
3.2 Transporting the machine
Check the transport packaging and the attached shock indicator
(ShockWatch®) immediately upon receipt for visible damage. Damage
must be recorded in written and image form and then immediately
reported to the transport company and Rapid Shape.
Lift the machine by two people and carry it to the destination. When
using lifting and transport means, these must be designed for the
weight of the machine. (→ Chapter 12)
To Next Page
Loading...
Need help?
General
