Rapid Shape D30+ - Unpacking the Machine; Scope of Delivery; Storing the Machine

Operating instructions D30+ │ P30+ │ SheraPrint 30
17 │ 44
Rapid Shape GmbH │ DOCR000231
3.3 Unpacking the machine
For unpacking the machine please proceed as follows:
1. Open the lid of the transport box.
2. Remove all transport box brackets and set them aside.
3. Remove all side panels from the transport box.
4. Remove the foam protective cover on the top of the machine.
5. Loosen the transport belt around the machine with a pair of
scissors or a blade. When doing so, be careful not to damage
the machine.
6. Set up the machine. → Chapter 4.2.2
Store all parts of the transport box safely for future
transport of the machine. Returns without original
packaging cannot be accepted.
3.4 Scope of delivery
The standard delivery includes the following parts:
— 3D printing system
— Starter package
Optionally, additional accessories can be supplied. For more
information, please contact Rapid Shape.
3.5 Storing the machine
Store the machine
— in a dry, dust-free and frost protected room.
— on a horizontal base.
— with closed protective hood.
— ideally in the original packaging.
Also make sure that no consumables residues remain in the machine.