Operating instructions D30+ │ P30+ │ SheraPrint 30
Rapid Shape GmbH │ DOCR000231
You can pause or prematurely end a running print job at any time (for
example, in the case of a failed or incorrect job). To pause/end a job
please proceed as follows:
1. Progress summary: Press the 'Pause' button to pause the current
print job.
The last layer is cured, then the printing process is stopped.
2. Press the 'Continue' button to resume the paused printing
process.
3. By pressing the 'Cancel' button, you can end a print job early.
We do not recommend pausing the print job as the
interrupted layer may not adhere properly due to too
much exposure to oxygen.
The peeling of the components from the building platform occurs
automatically after each print job. After completion of the job, the
machine locks the hood and the platform moves to the peeling
position. The collection basket is positioned under the platform.
As soon as the platform stops moving, the blade moves below the
platform and peels off the components. The components fall into the
collecting basket. The blade moves back to the safe parking position.
The hood is unlocked and the components can be removed. If already
included in the job list, the next print job starts.
To remove your components from the machine, please proceed as
follows:
1. Prerequisite: The print job was peeled off the building platform
→ Chapter 8.6
2. Wear protective gloves on your hands.
3. Open the machine.
4. Lift the collection basket with the components from the basket
holder and remove the basket from the machine.
Make sure that dripping material does not lead to soiling of the
surroundings
5. Start now with the post-processing of your job. → Chapter 8.8
6. As soon as possible, put the basket back into the machine and
confirm that the basket has been put back into the machine
(empty). Then the machine is ready for the next peeling process.
Avoid negative effects on your print job due to too long
subsequent UV radiation. This can polymerise liquid
residue and affect the quality of your job.
To Next Page
Loading...
Need help?
General
