Operating instructions D30+ │ P30+ │ SheraPrint 30
Rapid Shape GmbH │ DOCR000231
Special safety instructions
In order to draw attention to particular dangers, the following symbols
are used in safety notices:
Warning: dangerous electrical voltage
This symbol highlights useful tips and recommendations,
as well as information for efficient and trouble-free
operation.
The 3D printing system is designed for the printing of three dimensional
objects with wavelength and DLP suitable printing materials (flash point
>80°C) in additive production (DLP-processing). The digital workflow
(→ Chapter 1.2.1) is to be observed.
The printer system is designed for temperature controlled interiors.
(→ Chapter 12)
Proper use requires compliance with all information in this manual.
Any use going beyond the intended use or otherwise is deemed to be
improper. The operator is exclusively liable for any resulting damage.
Use contrary to the intended use includes, but is not limited to the
following actions:
— Operation within potentially explosive areas
— Operation with explosion-hazardous printing materials
— Outdoor operation
— Operation in tropical climates
— Operation in wet, damp rooms
— Operation without sufficient instruction
— Operation without material reservoir and without building
platform
— Operation with defective or modified safety devices
— Operation without mandatory safety equipment
— Operation with unauthorised spare parts
— Operation with non-wavelength and printing materials not
suitable for DLP processing.
— Remove or change the attached safety markings
— Improper conversions, modifications, repairs and maintenance
To Next Page
Loading...
Need help?
General
