Operating instructions D30+ │ P30+ │ SheraPrint 30
Rapid Shape GmbH │ DOCR000231
8.2 Switching on the machine
To switch on the machine, please proceed as follows:
1. Prerequisite: The machine has already been fully connected.
→ Chapter 4.3
2. Switch on the machine using the main switch.
— The machine is started, the display shows 'starting
machine'.
— The Z-axis carries out a reference run in the direction of
the upper end position.
— The user interface of the display starts, the Home screen
is displayed. → Chapter 7
In order to make the operation of the machine even
more comfortable, supporting messages appear at
some operating points. For an optimisation of your
printing processes and printing results, every message
with a recommendation for action is displayed.
When starting the machine, the following supporting
messages appear:
— If inserted, information about the material
reservoir
— Available updates for the machine
The available updates will not be displayed if the
'Automatic Updates' function is disabled.
(
'
Setup
'
→
'Service'
→
'Customer')
— Basic information about your machine
(for example license status)
8.3 Open and close the machine
The machine has an automatic or manually opening/closing hood.
To open/close this, please proceed as follows:
Automatic:
1. Press on the touch point of the automatic hood opening.
If the hood is in the closed position, the machine now opens
automatically.
If the hood is in the open position, the machine closes.
Manual:
1. Grasp the lateral grips of the hood with both hands.
2. To open the machine, pull and push the hood upwards until it is
located in its end position.
3. To close the machine, pull and push the hood down until the
hood is closed flush with the housing.
To protect the printing material against the effects of light and dust, the
machine automatically closes after a preset time (During printing after
30 seconds, in the main menu after 60 seconds.)
To Next Page
Loading...
Need help?
General
