The material reservoir is a wearing part and must be
replaced in case of damage to the silicone surface, e.g.
in case of blistering, scratches and clouding.
Protective gloves, microfibre cloth, Isopropanol, glass cleaner, material
bottle, fine sieve, collecting container │ Operator
For cleaning a filled material reservoir, please proceed as follows:
1. Wear protective gloves on your hands.
2. Clean the underside of the material reservoir with a microfibre
cloth soaked in isopropanol.
3. Then clean the underside of the reservoir with a microfibre cloth
soaked in glass cleaner
4. If present, remove any cured particles in the printing material
with automatic reservoir cleaning. → Chapter 10.2.5
To clean an empty material reservoir, or for the complete cleaning of a
filled material reservoir, please proceed as follows:
1. Wear protective gloves on your hands.
2. Empty the material in the reservoir over one of the filling
openings into a material bottle. On this occasion it makes sense
to filter the material at the same time.
3. Fill isopropanol in the reservoir.
4. Carefully mix the isopropanol with a silicone spatula to loosen
the material residues from the bottom of the reservoir and to
bind them in isopropanol.
5. Then empty the mixture of isopropanol and material via one of
the filling openings in a collecting container.
If necessary, repeat this procedure with fresh isopropanol.
6. Dab dry the reservoir gently with a microfibre cloth.
Never rub!
7. Clean the underside of the material reservoir with a microfibre
cloth soaked in isopropanol.
8. Then clean the underside of the reservoir with a microfibre cloth
soaked in glass cleaner
To Next Page
Loading...
Need help?
General
