Rapid Shape D30+ - Netfabb

Operating instructions D30+ │ P30+ │ SheraPrint 30
Rapid Shape GmbH │ DOCR000231
22 │ 44
IP address
By default, the 3D printer system is set to DHCP (dynamic IP address). If
you want to use a static IP address, it can be set in the 'Settings' menu
of your machine.
6.4 Netfabb
The slicing software 'netfabb' is needed for the further processing of
your print file.
For further information on the operation of netfabb,
refer to the separately available operating instructions.
→ netfabb