Rapid Shape D30+ User Manual

Operating instructions D30+ │ P30+ │ SheraPrint 30
7 │ 44
Rapid Shape GmbH │ DOCR000231
1.2.1 Digital Workflow
1
Creation of
3D data
2
Processing
the 3D data
3
Preparation
of 3D data
for the printer
system
4
Printing the
3D
components
5
Post-
processing
6
Use of the
component
The 3D printer system described in this manual is part of the digital
workflow and is used in steps 3 and 4.
1.3 Safety equipment
General
WA RNIN G!
Danger with non-functioning or dismantled safety
devices!
Safety equipment must be checked for function each
time the printer is turned on. These may not be removed
or changed. Improperly functioning or removed safety
devices can lead to life threatening injuries.
— All safety equipment must be checked for
function each time the printer is turned on.
— If the safety devices are not functioning correctly,
the operation must be stopped immediately.
Defective safety devices must be replaced
immediately.
Safety covers
(Protective hood)
The protective covers of the printer protect against direct contact with
the live electrical equipment of the printer and direct exposure to UV
radiation. They must not be removed or opened during operation.
Check that all safety covers are firmly installed and can be completely
closed.

Rapid Shape D30+ Specifications

General

Brand	Rapid Shape
Model	D30+
Category	3D Printers
Language	English