Fault messages
194 / 203
fault indication when and how remedial action
cooking cabinet thoroughly with the hand
shower (also behind the air baffle).
- The unit can be used for cooking
temporarily.
Please notify Customer Service.
Service 26 Displayed
continuously.
If the fault message occurs during CleanJet
®
cleaning, please run "Interrupt CleanJet
®
. If
the fault message continues to be displayed
after running "Interrupt CleanJet
®
", remove
the tabs from the cooking cabinet and rinse
the cooking cabinet thoroughly with the hand
shower (also behind the air baffle). Please
notify Customer Service.
Service 27 When it has been
switched on for 30
seconds,
CleanJet
®
+care is not possible. Switch off
the power at the mains for 5 seconds, then
switch on again.
Service 28 When it has been
switched on for 30
seconds,
Please notify Customer Service.
Service 29 Displayed
continuously.
Check the air filter under the control panel,
and clean or replace if necessary. Check
whether the unit is being affected by an
external heat source. If the service message
persists, notify Customer Service.
Service 31 When it has been
switched on for 30
seconds,
Core temperature probe is defective. The
unit can be used for cooking without the core
temperature probe. Please notify Customer
Service.
Service 32 Gas
units
Displayed
continuously.
Close the gas valve. Please notify Customer
Service.
Service 33 Gas
units
This is displayed
continuously after
being reset 4 times.
Close the gas valve. Please notify Customer
Service.
Service 34 Displayed
continuously.
Follow any requests shown on the display,
if the fault is not eliminated, please notify
Customer Service.
To Next Page
Loading...
