General commissioning (all machine types) 8
80
Mechanical display of the spreading position
The mechanical display of the spreading position is located directly at the right
side of TELIMAT relative to the direction of travel. The display can be seen from
the driver's cab of the tractor.
Figure 8.25: TELIMAT mechanical display
[A] Boundary spreading position
[B] Normal spreading position
NOTICE
When older control equipment is used, leaks are possible during boundary
spreading. In such case, TELIMAT may leave the already reached end position
(lower position) again. Therefore, return TELIMAT to the end position at regular
intervals in order to prevent spreading errors.
To Next Page
Loading...
