Rauch AXIS-M 20.2 EMC - B.2 Using the Fertiliser Chart

Spreading operation
99
B
AXIS
AXIS 20.1
AXIS 20.2
B.2 Using the fertiliser chart
B.3 Spreading at the headland
B.4 Adjusting the application rate
B.4.1 Version Q/W/EMC
NOTICE
Please observe chapter 8.6: Using the fertiliser chart, page 64
.
NOTICE
Please observe chapter 8.7: Spreading at the headland, page 71
.
NOTICE
The machines of the versions Q, W and EMC include electronic slide actuators
for setting the application rate.
The electronic slide actuator is described in a separate operator’s manual for the
operating unit. This operator’s manual is an integral part of the operating unit.
n CAUTION
Damage to property caused by incorrect positioning of the
metering slide
If the stop levers are positioned incorrectly, the operation of the
actuators via the QUANTRON operating unit may cause damage
to the metering slides.
 Always clamp the stop levers at the maximum scale position.
K
D
R
C
Q
W
EMC