Rauch AXIS-M 20.2 EMC - Maximum Admissible Mounting Height at Front (V) and Rear (H)

General commissioning (all machine types)
59
8
AXISAXIS
8.5.2 Maximum admissible mounting height at front (V) and rear (H)
The maximum admissible mounting height (V + H) is measured from the
ground to the lower edge of the frame.
Figure 8.9: Maximum admissible mounting height V and H during normal and
late fertilising
The maximum admissible mounting height depends on the following factors:
 Normal or late fertilising.
Machine type
Maximum admissible mounting height
during normal fertilis-
ing
during late fertilising
V [mm] H [mm] V [mm] H [mm]
AXIS 20.2/
AXIS 30.2/AXIS 40.2
1040 1040 950 1010
AXIS 50.2 990 990 900 960
V
H