Rauch AXIS-M 20.2 EMC - C.6.1 Checking AXIS 50.2 D

Maintenance and repair
191
C
AXIS 50.2
C.6.1 Checking AXIS 50.2 D:
1. Attach a suitably thin string [1] from below at the rear in the direction of travel
(as shown) through the grooves [a] of the left and right adjustment centres
and tauten it.
Figure 28: Checking the drop point
 The string has to run straightly through the groove [a] at the both hopper bas-
es without any pressure and be in contact with edge [b].
 If there is no contact between the string and the edge, the drop point must be
readjusted.
K
D
R
C
Q
W