Rauch AXIS-M 20.2 EMC - 7 Instructions Regarding the Spreading Operation

Instructions regarding the spreading operation
47
7
AXISAXIS
7 Instructions regarding the spreading operation
The intended use of the machine includes compliance with the operating, main-
tenance, and service conditions in accordance with the manufacturer specifica-
tions. Spreading therefore always includes preparation and
cleaning/maintenance.
 Carry out spreading operations in accordance with the sequence described
below.
Preparation
 Installing the spreader on the tractor Page 54
 Close metering slide
 Presetting the mounting height Page 58
 Filling in the fertiliser Chapter A.2 or chapter A.3
1
1. See the register of your machine (AXIS 20.2, AXIS 30.2 or AXIS 50.2)

Adjusting the application rate Chapter B.2
1
 Setting the working width
- Selection of the correct spreading disc
- Adjusting the drop point
Chapter B.5
1
Chapter B.5.3
1
Spreading
 Travel to the spreading location
 Check the mounting height
 Engage the PTO shaft
 Open the slider and start spreading
 Finish spreading operations, and close the
slides
 Disengage the PTO shaft
 Discharge residual material Chapter B.10
1
Cleaning/maintenance
 Open metering slide
 Remove the spreader from the tractor
 Cleaning and maintenance
Chapter C
1
and AXIS mainte-
nance