Rauch AXIS-M 20.2 EMC - C.6.3 Checking AXIS 50.2 W

Maintenance and repair
193
C
AXIS 50.2
C.6.3 Checking AXIS 50.2 W
 If the mark is not aligned to the string, the drop point must be readjusted.
1. Attach a suitably thin string
at the rear in the direction of
travel (as shown) to the low-
er sides of the left and right
adjustment centres and taut-
en it.
Figure 30: Attaching the string to the ad-
justment centre
2. The triangular mark on the
adjustment centre must co-
incide with the tensioned
string.
Figure 31: Markings on the adjustment
centre
NOTICE
For adjustment of the drop point settings, please contact your dealer or an au-
thorised specialist workshop.
K
D
R
C
Q
W