Rauch AXIS-M 20.2 EMC - Setting the Boundary Spreading Unit GSE (Optional Equipment)

General commissioning (all machine types) 8
76
AXISAXIS
8.9 Setting the boundary spreading unit GSE (optional equipment)
The boundary spreading unit limits the spreading width (either towards the left or
right) to a range between approx. 0 m and 3 m from the centre of the tractor track
to the outer edge of the field.
 Close the metering slider that points to the edge of the field.
 Fold the boundary spreading unit downwards for boundary spreading.
 The boundary spreading unit must be folded up again before starting the two-
sided
spreading.
Figure 8.23: Setting the boundary spreading unit
[1] Numeric scale, left side
[2] Adjustment nut for numerical scale
[3] Indicator
[4] Hand grip
[5] Numeric scale, right side
1. The position of the pointer [3] is to be obtained from the assembly instruction
manual included in the scope of delivery.
2. Loosen the adjustment nut [2] for the numeric scale using the adjustment
lever of the machine.
3. Slide the numeric scale so that the pointer is directed to the value determined.
Use the hand grip [4] for this purpose.
4. Loosen the adjustment nut [2] for the numeric scale using the adjustment
lever of the machine.
NOTICE
The settings for the boundary spreading unit refer to the spreading disc work-
ing towards the inside of the field.
5
1
2
3
3
2
4