Rauch AXIS-M 20.2 EMC - Fitting and Removing the PTO Shaft

General commissioning (all machine types)
51
8
AXISAXIS
8.3.1 Fitting and removing the PTO shaft
Fitting:
1. Check the installation position.
 The drive shaft end that is marked with a tractor symbol must point to the
tractor.
2. Loosen the locking screw [1]
of the universal drive shaft
guard.
3. Turn the universal drive shaft
guard to the demounting
position.
4. Pull the universal drive shaft
out.
Figure 8.1: Loosen the universal drive shaft
guard
5. Remove the
spigot protection
and grease the transmission
spigot.
6.
Push the universal drive shaft
onto the transmission spigot.
Figure 8.2: Push the universal drive shaft
onto the transmission spigot
1