Spreading operation B
140
Implementation (example on the left side of the spreader):
Figure 11: Attach the calibration test chute
4. Suspend the calibration test chute under the left output (in the direction of
travel).
NOTICE
The calibration has to be carried out at one side of the machine only. For safety
reasons, however, both spreading discs must be removed.
1. Use the adjustment lever to
loosen the cap nut of the
spreading disc.
2. Remove the spreading disc
from the hub.
Figure 10: Loosen the cap nut
3. Set the drop point to
position 0.
To Next Page
Loading...
