Spreading operation B
168
AXIS 50.2 W
With the selection of the spreading disc type, you can specify a particular range
for the working width. By altering the drop point, the working width can be accu-
rately set and adjustments to different fertiliser types can be made.
You can set the drop point via the upper scale arc.
Adjusting in the direction of smaller numbers: The fertiliser is ejected sooner.
This results in spreading patterns for smaller working widths.
Adjusting in the direction of larger numbers: The fertiliser is ejected later and
spread more towards the outside into the overlap zones. This results in
spreading patterns for larger working widths.
Figure 7: Drop point gauge
NOTICE
The machine version W is equipped with an electronic drop point adjustment.
The electronic drop point adjustment is described in a separate operating man-
ual for the operating unit. This operator’s manual is an integral part of the oper-
ating unit.
To Next Page
Loading...
