Maintenance and repair C
186
2. Tighten the screw connec-
tion [1] with a torque wrench
(Tightening torque =
65 Nm).
Figure 21: Fastening the tie rod at the
weigh frame
3. Tighten the screw connec-
tion with a torque wrench
(Tightening torque =
65 Nm).
Figure 22: Fastening the tie rod at the
hopper
NOTICE
After tightening the screw connections using the torque wrench, the weighing
cells must be tared anew. Please follow the instructions in the chapter “Machine
tare" of the operator’s manual of the operating unit.
To Next Page
Loading...
